YNV12T05 DC-DC Converter Data Sheet
9.6-14 VDC Input; 0.7525-5.5 VDC Programmable @ 5 A
The input voltage must be typically 9.2 V for the
V 0-REG [V] R TRIM [k ? ]
Table 1: Trim Resistor Value
The Closest
Standard Value [k ? ]
converter to turn on. Once the converter has been
turned on, it will shut off when the input voltage
drops below typically 8.4 V.
0.7525
1.0
1.2
1.5
1.8
2.0
2.5
3.3
5.0
5.5
open
41.42 41.2
22.46 22.6
13.05 13.0
9.02 9.09
7.42 7.50
5.01 4.99
3.12 3.09
1.47 1.47
1.21 1.21
Output Overcurrent Protection (OCP)
The converter is protected against overcurrent and
short circuit conditions. Upon sensing an overcurrent
condition, the converter will enter hiccup mode. Once
over-load or short circuit condition is removed, Vout
will return to nominal value.
Overtemperature Protection (OTP)
The output voltage can also be programmed by an
external voltage source. To make trimming less
sensitive, a series external resistor Rext is
recommended between TRIM pin and programming
voltage source. Control Voltage can be calculated by
the formula:
The converter will shut down under an
overtemperature condition to protect itself from
overheating caused by operation outside the thermal
derating curves, or operation in abnormal conditions
such as system fan failure. After the converter has
cooled to a safe operating temperature, it will
automatically restart.
V CTRL ? 0 . 7 ?
(1 ? R EXT )(V O -REQ - 0.7525)
15
[V]
Safety Requirements
where,
V CTRL ? Control voltage [V]
R EXT ? External resistor between TRIM pin and
voltage source; the k ? value can be chosen
depending on the required output voltage range.
The control voltages with R EXT ? 0 and R EXT ? 15 k ?
are shown in Table 2.
Table 2: Control Voltage [VDC]
V 0-REG [V] V CTRL (R EXT = 0) V CTRL (R EXT = 15 k ? )
0.7525 0.700 0.700
1.0 0.684 0.436
1.2 0.670 0.223
1.5 0.650 -0.097
1.8 0.630 -0.417
2.0 0.617 -0.631
2.5 0.584 -1.164
3.3 0.530 -2.017
5.0 0.417 -3.831
5.5 0.384 -4.364
Protection Features
Input Under-Voltage Lockout
Input under-voltage lockout is standard with this
converter. The converter will shut down when the
input voltage drops below a pre-determined voltage;
it will start automatically when Vin returns to a
specified range.
The converter meets North American and
International safety regulatory requirements per
UL60950 and EN60950. The maximum DC voltage
between any two pins is Vin under all operating
conditions. Therefore, the unit has ELV (extra low
voltage) output; it meets SELV requirements under
the condition that all input voltages are ELV.
The converter is not internally fused. To comply with
safety agencies requirements, a recognized fuse
with a maximum rating of 7.5 Amps must be used in
series with the input line.
Characterization
General Information
The converter has been characterized for many
operational aspects, to include thermal derating
(maximum load current as a function of ambient
temperature and airflow) for vertical and horizontal
mounting, efficiency, start-up and shutdown
parameters, output ripple and noise, transient
response to load step-change, overload, and short
circuit.
The figures are numbered as Fig. x.y, where x
indicates the different output voltages, and y
associates with specific plots (y = 1 for the vertical
thermal derating, …). For example, Fig. x.1 will refer
to the vertical thermal derating for all the output
voltages in general.
MCD10201 Rev. 1.0, 24-Jun-10
Page 6 of 26
www.power-one.com
相关PDF资料
YNV12T10-0 CONVERT DC/DC 33W T/H
YS05S10-0 CONVERT DC/DC 36.3W SMD
YS05S16-0 CONVERT DC/DC 58W SMD
YS12S10-DG CONVERT DC/DC 55W SMD
YS12S16-0 CONVERT DC/DC 88W SMD
YV12T25-0 CONVERT DC/DC 137W T/H
ZA5350-B CLIP TERM W/8"CORD BARE
ZA5350 CLIP TERM W/8"CORD & DC PLUG
相关代理商/技术参数
YNV12T05G 制造商:Power-One 功能描述:Module DC-DC 1-OUT 0.7525V to 5.5V 5A 27.5W 5-Pin SIP
YNV12T05-G 功能描述:DC/DC转换器 0.7525-5.5Vout 5A 9.6-14VIn RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
YNV12T05-G-Q 制造商:Power-One 功能描述:DC/DC CONVERTER 0.7525-5.5V 28W
YNV12T10-0 功能描述:DC/DC转换器 RoHS:否 制造商:Murata 产品: 输出功率: 输入电压范围:3.6 V to 5.5 V 输入电压(标称): 输出端数量:1 输出电压(通道 1):3.3 V 输出电流(通道 1):600 mA 输出电压(通道 2): 输出电流(通道 2): 安装风格:SMD/SMT 封装 / 箱体尺寸:
YNV12T10010-0 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 1V 10A 50W 10SIP - Bulk
YNV12T10010-0G 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 1V 10A 50W 10SIP - Bulk
YNV12T10010-D 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 1V 10A 50W 10SIP - Bulk
YNV12T10010-DG 制造商:Power-One 功能描述:DC/DC PS SGL-OUT 1V 10A 50W 10SIP - Bulk